Pay in 4 interest-free payments of $21.15 Learn more
Ships within 48 hours · Estimated delivery Aug 1 - Aug 6
5” Billet screw-on fill cap with integrated high flow roll over vent valve to ensure no vacuum or pressure build up and prevent fuel spillage in the event of an accident
6061-T6 aluminum construction with a black powder coated finish and bolts
’01 housings are stamped PBW2 and have the reverse shaft location that was moved to accommodate the 3
You can also measure at the valve tip as below
SpeedFactory 3 Bar MAP (Manifold Absolute Pressure) sensors use state of the art bipolar op amp circuitry with thin film resistor networks built into each micro chip
SpeedFactory Racing Titanium VTEC Eliminator Pin Kit for Honda H Series SF Parts 5” Billet screw-on fill capSpeedFactory Racing Titanium VTEC Eliminator Pin Kit for Honda H Series These pin kits are designed to be used in drag race applications where the engine is operated at high RPM with limited idle low rpm use, not in a street car. 8 Pins for locking VTEC on all H Series VTEC engines Lightweight Titanium, 37% lighter than stock pins (8. 3g per rocker assembly) VTEC solenoid can be left in place, or a block off plate can be utilized LMA's can be left in
US$ 41.90
US$ 349.50
US$ 249.50
US$ 119.50
US$ 349.50
US$ 249.50
US$ 188.97
US$ 4650.00
US$ 3350.00
US$ 5050.00
US$ 45.00
US$ 99.00
US$ 48.00