7’1” Jive Space Elevator candles&incense 5'8" x 20" x 2

5'8" x 20" x 2

Due to it's greater than average amount of nose rocker

you can find a single concave entry

a full pointed nose

The outlines wide point is set slightly behind center and the nose and tail pull in quickly into a pin

7’1” Jive Space Elevator candles&incense 5'8" x 20" x 28'1" x 21 1 2" x 2 15 16" Jacob Ells is a Santa Barbara based shaper who is always looking to push the boundaries of alternative boards. The Space Elevator model was made to trim with long parallel foiled rails, pulled in nose, and rounded tail. The rocker of the board is low allowing for high down the line speed. The bottom contour is quite interesting starting flat in the nose and quickly turning into a tri plane hull with a deep single concave that